Tuya Zigbee Smart Switch Module with 4-Channel Relay, 2200W/10A Circuit Control, Remote Control, WiFi & RF 433MHz, ≤36V Operating Voltage, No Battery Needed

This Tuya Zigbee Smart Switch Module features a Micro USB 5V input, 4-Channel Relay, and 2200W/10A circuit control. It includes wall-mount remote control capabilities and supports both WiFi and RF 433MHz connectivity. Operating voltage is ≤36V with no battery required for operation.

Make sure to have a Zigbee hub available before using the device. Attempt to pair the device in close proximity to the Zigbee hub.Implement device flow in the mobile application. Here is a demonstration of how to add a device to the Tuya Zigbee gateway.Once the installation is complete, turn on the device and check that the network indicator is flashing 'Status'. Then, select the Zigbee gateway card. If the network indicator is not flashing, you can reset the device by pressing and holding any manual switch for 8 seconds. Click on 'Add subdevice'. Wait for approximately 1 minute until the device is detected, and then click on 'Done'.After successfully adding, go back to the main interface of tuya to view the newly added device. You can perform remote control when the network indicator light of the device is on.The remote control and the code are synchronized through the following steps: First, press and hold the manual switch for 3 seconds until the RF pairing indicator (blue light) turns on. Next, press and hold the buttons on the remote control. Finally, release the buttons on the remote control to complete the synchronization process. To clear the code, press and hold the manual switch for 15 seconds (RF pairing indicator remains on), then release the manual switch when the RF pairing indicator turns off.Please note that the method for matching/clearing codes is only accessible with the RF function switch/module reference. TROUBLESHOOTING: Resolving issues with product matching and offline functionality: Access the App homepage and tap on the icon located in the bottom right corner of the interface to enter.