1pc 433MHz Wireless Relay RF Remote Control Switch Receiver, 4 Channel, Wall Mount, Shock-Resistant, for Computers, Non-Waterproof, Hardwired, ≤36V, DC 12V 24V 36V 10A, Orange Transmitter

This is a single piece of a 433MHz Wireless Relay RF Remote Control Switch Receiver with 4 channels. It is designed to be mounted on the wall and is shock-resistant. This device operates on radio frequency and is suitable for use with computers. It is not waterproof and needs to be hardwired. It can handle a maximum voltage of ≤36V, specifically DC 12V 24V 36V at 10A. Please note that the orange transmitter is not included.

4-channel RF wireless remote control switch with a radio receiver, featuring a copper rubber stick antenna and a metal transmitter with four buttons, compatible with 12V, 24V, and 36V.Receiver: Model Number: AK-C211008 1. Operating voltage: DC12V-36V 2. Standby current: Under 6mA 3. Operating temperature: -40 Degrees to +80 Degrees 4. Receiver sensitivity: greater than -105dBm 5. Operating frequency: 433mhz 6. Output voltage: DC or AC available 7. Maximum load current: 10AThe method of operation has been modified by the Learning button. For momentary action, press the Learning Button once; for the relay, press and hold to turn on, and release to turn off. To toggle, press the Learning Button twice; for the relay, press to turn on and press the same button again to turn off. For latched action, press the Learning Button three times; for the relay, press to turn on and press a different button to turn off. For a combination of 2-channel momentary and 2-channel latched, press the Learning Button four times. For a combination of 2-channel momentary and 2-channel toggle, press the Learning Button five times.To toggle between 2channel and latched modes, press the learning button six times. Method for learning and clearing: To learn, press the learning button until the indicator flashes and turns off, then release your finger. Next, press any button on the remote transmitter; the indicator will flash three times, indicating that the learning process was successful. (The number of times you press the learning button depends on the desired operation mode.)To clear the code, press and hold the learning button for approximately 8 seconds until the indicator light blinks several times and then turns off. After that, press the remote; if the relay does not respond, it indicates that the code has been cleared successfully.Transmitter: 1. Controls: 4 Buttons 2. Power Supply: DC3V using 2 AA batteries (batteries not included) 3. Frequency: 433MHz 4. Range: 100-200 meters 5. Current Consumption: 13 mAh 6. Encoding: EV1527 codePlease be aware that for safety reasons, the remote control is shipped without AA batteries. Kindly purchase your own batteries after receiving the item. Thank you!